Hi,
I have a requirement where my user needs the DMR at lot level where they do not need the inspection severity to be picked from DMR because the inspection plan has got different sampling procedures for respective MIC's.
Example:
Create a inspection plan with 3 MIC's for a material as shown below which is having active inspection type as 01: Inspection lot against GR
| MIC | Sampling procedure | Inspection severity for sampling procedure |
|---|---|---|
| Temperature | SAMP1 | SEV1 (for 100 lot size, sample size =5) |
| Length | SAMP2 | SEV2 (for 100 lot size, sample size = 8) |
| Width | SAMP3 | SEV3 (for 100 lot size, sample size = 2) |
DMR at lot level is assigned to the inspection plan
DMR is defined as given below:
| Stage | Insp severity | Skip | Initial | No. of OK inspections | New stage if OK | No. of not ok insp's | New stage if not OK |
|---|---|---|---|---|---|---|---|
| 1 | sev1 | yes | 2 | 1 | |||
| 2 | yes | 1 | 1 | ||||
When a inspection lot is created against a GR for 100 lot quantity for this material then system will show the sample size in the results recording screen by considering the DMR inspection severity for all MIC's as shown below.
| MIC | To inspect | Inspected | Result |
|---|---|---|---|
| Temperature | 5 | ||
| Length | 5 | ||
| Width | 5 |
My requirement is system should propose me the sampling size as per the sampling procedures assigned to the MIC's in theinspection plan as shown below:
| MIC | To inspect | Inspected | Result |
|---|---|---|---|
| Temperature | 5 | ||
| Length | 8 | ||
| Width | 2 |
Lots should be skipped normally as shown in the DMR but sample size should be calculated from the sampling procedure assigned to the MIC.
Please help me out if there is any standard practice in SAP for this requirement.
Thank you.